10)
For key valve assembly sequence is the same for either Natural Gas or LP.
Flex Line > Fitting > Valve > Elbow > Gas Supply Flex Line
11)
Connect fuel supply line to Key Valve.
12)
Perform leak test as described in this manual. Perform leak test on all fittings
and back pressure checks for LP with media installed.
13)
Install unit in enclosure.
To reduce whistling ensure any flex line does not have sharp bends.
Key Valve Configuration
8)
Fire Pit Operation
WARNING:
Before use, be sure to test all gas connections for leaks. Do not use fire pit if there is any evidence of leaking gas. If
leaking gas suspected, turn off the main gas supply and repair immediately.
WARNING:
Wind and gusty conditions will affect the flame in an unpredictable manner. If conditions exist that are not safe for
patrons turn the fire pit off.
WARNING:
Do not use fire pit if any part has been submerged under water. Immediately call a qualified service technician to
inspect the fire pit.
WARNING:
Never use any material that is non-porous and holds moisture such as gravel, pebbles, river rock, etc. This material,
when heated will cause the trapped moisture to boil and fracture unexpectedly. This material is not sufficiently porous to allow
heated steam to readily escape which can break and cause personal injury or damage.
WARNING:
Solid fuels shall not be burned in the fire pit. Leaves, sticks, wood, paper, clothing, food material, should be kept
away from the fire pit. Make sure that there is no vegetation or other objects over the top or sides of the fire pit that could interfere
with safe operation. See clearances in Section 2 Selecting the Location.
WARNING:
If lava rock is wet, allow fire pit to burn for 45 minutes prior to coming within 15 feet of the fire pit.
WARNING:
When fire pit is not in operation turn off gas valve.
WARRANTY REQUIREMENT: When not in use the fire pit must be covered at all times.
IMPORTANT
:
Initial
Start-up:
It may be necessary to purge air in gas lines after system installation
.
START UP
1.
STOP! Read the safety information on “What to do if you smell gas” (Pg. 1).
2.
Confirm fire pit is clear of debris and that all covers are removed.
3.
Place long handled lighter or match while burning on top of the fire pit.
4.
Slowly turn “ON” gas valve.
5.
After burner lights remove lighter or match.
6.
Adjust flame to desired height.
7.
If burner does not light turn valve off and allow gas to clear then repeat steps 3~7.
8.
Never alter the design of the fire pit.
9.
Never leave fire pit unattended- should be supervised by an adult familiar with emergency shut off.
10.
Flammable materials should not be placed on or near the fire pit.
11.
Children should be supervised when they are in vicinity of the fire pit.
