Getting Started….QUICKLY!
By this point, you should know the COM port that was as
‐
signed to your modem. Your ZigBee Modem should be
plugged in and the USB LED lit. Please do not proceed until
you have determined the correct COM port.
Step 4:
The next thing we need to do is locate the PGM/RUN jumper
and set this jumper to “PGM”. This jumper sets the controller
to PROGRAM mode. Use PROGRAM mode anytime you want
to change the controllers settings. RUN mode is for normal
daily use. RUN mode protects the memory from accidental
changes. It is not possible to make changes to the settings of
this controller if the jumper is set to RUN mode.
THIS DEVICE ONLY READS JUMPER SETTINGS WHEN POWER IS
FIRST APPLIED TO THE CONTROLLER. JUMPER CHANGES HAVE
NO EFFECT AFTER POWER UP. BE SURE TO POWER
‐
CYCLE THE
CONTROLLER EVERY TIME YOU CHANGE THE JUMPER SETTING.
Step 5:
The ZigBee Mirror Module requires a regulated 12V DC Power
Supply. The ZigBee Mirror Module is equipped with a 2.1mm
Center Positive Barrel Connector, used to supply power to the
device. If you do not have a compatible power supply avail
‐
able, a
PWR12 power supply is available from our web site
. It
is safe to use the ZigBee Mirror Module in automotive power
systems. Connect the power supply at this time.
Step 6:
Every ZigBee relay controller has a serial number printed on
the back of each ZigBee module. Carefully remove each ZigBee
Module, Record the type of Controller and the Last 8 Digits of
the Serial Number. DO NOT MIX UP THE ZIGBEE MODULES.
Reinstall the ZigBee module on the controller it came from,
making sure all pins are properly inserted into the socket. Your
log may look something like this:
Part:
Serial
Number:
ZR25
40018E66
(shown
at
right)
ZR25
40328E7F
ZR15
40321BFF
ZR85ProXR 40329F3E
ZR45ProXR 40328EF1
Every ZigBee Module will have a unique serial number. No two
controllers are ever alike. Please do NOT proceed until you
have logged the serial numbers of ALL controllers you plan to
associate with the ZigBee Mirror Module.
You do NOT need to
log the Serial Number of the ZigBee Mirror Module. DO NOT
POWER THE RELAY CONTROLLERS AT THIS TIME.
Step 7:
Install and Run the ZigBee Mirror software.
Step 8:
Choose the correct COM port for your system and Click the
“OK” button. (see previous page for complete instructions to
determine the correct COM port for your system).
Step 4: Set the PGM/RUN Jumper to
PGM. Use this setting ONLY when set
‐
ting up your ZigBee Mirror Module.
Step 5: Connect
PWR12
Power Supply at this location.
Step 8: Choose the COM Port for your system. Every system may
be different, so please follow the directions on the previous page.
Step 6: Remove the ZigBee Module
from each relay controller The com
‐
plete serial number is shown at left
with a red Box around it. You only
need the LAST 8 DIGITS of the serial
number. In the case of the module
shown, you will need 40018E66.
Logging your serial numbers will be
critical to proper configuration.
ZigBee Module Shown Removed
from the Relay Controller
