NBB Planar-D1, Operating Instructions Manual

Page: 30 / 66

30
Planar
®
-D1 / Compact-M2 R7
Activate transmitter
> Connect transmitter with existing receiver
The transmitter must be activated before operating the system! Proceed with your
transmitter as described in the following steps – within a few minutes your system is
ready for operation again.
1. The transmiter needs to be switched of to activate serial number mode.
2. Push SW 7 + SW 8 + SW 10 and hold for 5 seconds.
3. The 7-segment functional display will show “A” “d” “r” “s” , transmitter is ready to
ativate the serial number. The last 5 digits of the receiver serial number need to be
stored in the system one after the other.
4. Choose a number by pushing SW 1 + SW 2
5. Confirm a digit by pressing SW 9 , horizontal bars will light up. The input will automati-
cally proceed to the next digit.
6. Repeat step 4 and 5
7. After confirming the last digit the 5 entered digits will be shown again for checking
purposes.
8. Once prgramming is complete the transmitter will automatically be switched off.
Your system is now ready for operation.
SW3
SW5
SW7
SW9
SW2
SW4
SW6
SW8
SW10
SW1
SW11
1
2
3 4
5 6
7
8
2
1
3
5
4
Transmitter off
SW 7 + SW 8 + SW 10
press and hold 5 sec.
„A“ „d“ „r“ „s“
SW 1 + SW 2 choose number
SW 9 confirm number,
crossbars light up
Transmitter will be delivered uncoded!
Transmitter Planar®-D1