6.2 Panel Mount
The Panel Mount installation should be specified at the time of order; the ball-and-socket
mount system will not be included in the shipping box.
For installation, there are four tapped mounting holes on the four corners of the unit’s
rear panel. The mounting hardware packet is included with the product accessories in
the shipping box. This packet includes four (4) M4 stainless steel threaded studs,
8.6 cm (3” long), four (4) Nylock self-locking nuts and four (4) flat washers.
6.3 Installing the monitor consists of three steps:
1.
Attaching the monitor using one of the mounting interfaces built into the monitor’s
enclosure. (See 6.3.1 Step 1)
2.
Connecting the monitor to the computer and power source. (See 6.3.2 Step 2)
3.
Installing the touchscreen driver software. (See 6.3.3 Step 3)
6.3.1 Step 1 - Mounting the Monitor
The back of the monitor includes mounting points that you can use to mount the monitor
as your installation requires.
Mounting holes on the NavPixel™ NPD0835 allow the monitor to be mounted by rear
mounted using VESA75 or RAM mount
Mounting from rear:
z
VESA75 (4 hole pattern). Accepts
M4x0.7 up to 6mm depth.
z
RAM Mount (3 hole pattern)
Accepts M4x0.7 up to 6mm depth.
Page 14
