27
6.3.
Retrofitting from GD-1920C-BB (NavNet vx2) to TZT2BB
New
–
TZT2BB Configuration
Previous
–
GD-1920C-BB Configuration
Points:
(1)
Install the new
MCU-005
if a full keyboard operation is required, and add the POE injector to supply power to the MCU-005. Input NMEA0183 data to the NMEA2000 backbone via a converter such as the IF-NMEA2K2, or replace the NMEA0183
devices with NMEA2000 ones.
(2)
Replace the Radar dome or open array with the latest DRS
series.
(3)
The BBFF1 and BBFF3 are
NOT
compatible with the NavNet TZtouch/2 network.
BBFF1
: Replace with the
DFF1
,
BBDS1
, or just
connect the existing transducer to the built-in Fish Finder port
of the TZT2BB.
BBFF3
: Replace with the
DFF3
.
(4)
The FA-30 and FA-50 can be utilized.
(5)
While
NavNet vx2
MFDs support
10BASE-T
for Ethernet communications,
NavNet 3D, TZtouch, and TZtouch2
MFDs support
100BASE-TX
. If the existing hub is compatible with 10BASE-T, replace it with the one compatible with
100BASE-TX
or faster communications.
(6)
Use the standard supplied power cable to the TZT2BB processor unit.
(7)
If the monitor has the VGA (RGB) interface only, install a new monitor compatible with
HDMI (or DVI-D for connection via DVI-HDMI adapter)
.
(8)
Make sure that these monitors are compatible with the resolution of 1920×1080 (FHD), 1280×1024 (SVGA), and 1024×768 (XGA)
, which are output from the TZT2BB.
