25
6.2.
Retrofitting from MFDBB (NavNet 3D) to TZT2BB
New
–
TZT2BB Configuration
Previous
–
MFDBB Configuration
Points:
(1)
Convert the MCU-001 to MCU-005 or install the new MCU-005
if the full keyboard operation is required, and
add the supplied POE injector
to supply power to the MCU-005.
(2)
Input NMEA0183 data to the NMEA2000 backbone via a converter such as the IF-NMEA2K2, or replace the NMEA0183 devices with NMEA2000 ones.
(3)
Ethernet sensors compatible with NavNet 3D work with NavNet TZtouch2. However, note one point on network with DRS series Radar: While the MFDBB has the DRS power port for the DRS2D/4D/4A/6A/12A, the TZT2BB has no power port.
DRS2D/4D
: Add the
PSU-017
to supply power.
DRS4A/6A/12A
(and DRS2D/4D)
: Add the
PSU-012
. (The DRS2D/4D also works with the PSU-012.)
DRS25A
: It is already connected with the PSU-013. No additional wiring is necessary.
(4)
While the
MFDBB has four (4) BNC
connectors for analog cameras, the
TZT2BB has two (2) RCA
connectors. When utilizing the existing cameras, connect two of cameras to the TZT2BB ports via a BNC-RCA adapter.
(5)
Use the standard power cable to the TZT2BB processor unit.
(6)
If the monitor has the DVI-D interface only, connect the DVI cable to the processor unit via a DVI-HDMI adapter to fit on the HDMI port.
(7)
Make sure that these monitors are compatible with the resolution of 1920×1080 (FHD), 1280×1024 (SVGA), and 1024×768 (XGA)
, which are output from the TZT2BB.
