11
FUEL 3100 / DIESEL 3200
Installation and Operation Manual
NAVMAN
3 The setup menus
3-1 Setup data
Use the setup menus, shown on the following
pages, to customize the unit to suit your
boat and your own preferences. To display or
change setup data:
1 From the main display, press
ESC
and
ENT
together to start setup mode.
2 Press or one or more times to display
the setup menus.
3 Press
ENT
to select a setup menu.
4 Press or one or more times to display
the setup data for the setup menu.
5 If the boat has twin engines or twin tanks,
press
ENT
. Press one or more times to
display the port or starboard setup data.
6 To change the data:
i
Press
ENT
; the data will blink.
ii Press or hold or to change the
value.
iii Press
ENT
to accept the new value or
press
ESC
to ignore your changes.
7 To display or change other setup data for
this setup menu, repeat steps 4, 5 and 6.
Then press
ESC
.
8 To display or change setup data for other
setup menus, repeat steps 2 to 6. Finally,
press
ESC
to return to the main display.
3-2 Initial Setup
1 In the
FUEL
menu set up the number of
fuel tanks. Select
dUAL
then
Off
(1 tank)
or
On
(2 tanks).Then select the number of
engines. Motor (1 or 2).
2 In the
dSL SEn
Menu identify the motors
by:
i
Reset to single engine installation.
ii Select one motor (port or starboard),
then remove power from the
other motor’s diesel flow sensor
by unplugging the white coloured
connector.
iii Press and hold
ENT
for 2 seconds to
configure the motor, a beep will sound
when complete.
Repeat ii and iii for the other motor.
3 In the
SPEEd
menu identify the speed
input.
None, GPS or Sen
.
4 To reset all data to the factory defaults see
section 4-8
5 For single engine/ single tank diesel
installation factory defaults will work.