Version 13.10.2017
HW:25GD(V60)
VL3-MIB-STD2
P
a
g
e
6
1.4.1.
Enabling the interface’s video inputs (dip 1-3)
Only the enabled video inputs can be accessed when switching through the interface’s video
sources. It`s recommended to enable only the required inputs for the disabled will be
skipped when switching through the video-interfaces inputs.
1.4.2.
RGB-video input signal selection for after-market navigation (Dip 4)
If an after-market RGB navigation or other RGB video source is connected, the source’s RGB
output signal must match the interface’s RGB video input setting.
1.4.3.
Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory LVDS picture while the reverse gear is engaged
to display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input “Camera-IN” while the
reverse gear is engaged.
Note:
Dip 6,7 and 8 are out of function and have to be set to OFF
1.5.
Settings of the 4 Dip switches (CAN function - red)
Dip position down is
ON
and position up is
OFF
.
Navigation / Sy5tem
Dip 1
Dip 2
Dip 3
Dip 4
MIB- STD2 PQ /+NAV
OFF
OFF
OFF
OFF
Dip 1: To switch the AV sources both, by the steering wheel voice key button (not possible in
all vehicles) and keypad, set this switch to
OFF
. To switch the video sources only by
keypad, set to
ON
.
Dip 4: Debug mode for factory. Always set to
OFF
Dip 2 and Dip3 are out of function. Set to
OFF
After each Dip-switch-change a power-reset of the Can-box has to be performed!
