Version 13.10.2017
HW:25GD(V60)
VL3-MIB-STD2
P
a
g
e
17
2.7.
Picture settings and guide lines
The picture settings are adjusted by the 3 buttons on the video-interface. Press the MENU
button to open the OSD settings menu or to switch to the next menu item. Press UP and
DOWN will change the selected value. The buttons are embedded in the housing to avoid
accidental changes during or after installation. The picture settings have to be done
separately for RGB, AV1 and AV2 while the corresponding input is selected and visible on the
monitor. AV2 and Camera-IN share the same settings which must be adjusted in AV2.
Note:
The OSD menu is only shown when a working video source is connected to the
selected video-input of the interface.
The following settings are available:
Contrast
Brightness
Saturation
Position H (horizontal)
Position V (vertical)
For the rearIR-AV1 (out of function)
IR-AV2 (out of function)
Guide-lines left
Guide-lines right
Guide lines (ON/OFF)
Note:
If the video interface doesn’t receive CAN information, the guide-lines cannot be
used. If supported and activated, the guide-lines also show the steering wheel position
dependant driving path.
