Version 29.11.2022
HW: BOT(V43)(V54)
RL4-NAC12
P
a
g
e
14
2.3.3.
Installation with analogue connection (without CAN-Bus)
Connect the female 20pin connector of the 20pin interface cable to the male 20pin
connector of the video interface.
Connect the 20pin interface cable’s white wire “Manual ACC” to +12V
ACC
or to +12V
S-
contact
terminal 86s +12V
(e.g. glove compartment illumination).
Note: In case the analogue connection has to be made (because some vehicles are not
compatible), the input signal for each connected video source must also be manually
triggered via the corresponding 4 trigger lines
Trig-REAR
/
Trig-FRONT
/
Trig-RIGHT
/
Trig-LEFT
For analogue connection, don’t forget to set dip4 to OFF!
