Version 24.02.2021
HW CAM(V100) / (V35, V36, V40)
RL4-MIB2-E18
P
a
g
e
8
2.
Installation
Switch off ignition and disconnect the vehicle’s battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle to
“Sleep
-Mode
”
. In case it does not succeed,
disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
2.1.
Place of installation
The video interface is designated to be connected behind the vehicle`s head unit.
The daughter PCB shell be connected inside the factory head unit
’s monitor
and installed
behind the monitor panel, or below the DIN housing (e.g. Skoda Rapid).
