Operation
Mounting Height
Ground Axle
Load
10 in.
11 in.
12 in.
8,000 lbs
52 psi
56 psi
60 psi
9,000 lbs
60 psi
64 psi
69 psi
10,000 lbs
67 psi
72 psi
78 psi
11,000 lbs
75 psi
80 psi
87 psi
12,000 lbs
82 psi
88 psi
96 psi
13,000 lbs
90 psi
97 psi
105 psi
14,000 lbs
98 psi
105 psi
114 psi
1. This table is approximate. To obtain an accurate load vs. air
pressure reading, it is necessary that the unit be calibrated over a
flat and accurate scale.
2. These values are approximations and will vary, especially with
different mounting heights and or bag heights.
3. These Run Heights are based on units with no axle/bag shim
and a 3.50 in offset axle.
4. The values above are based on the standard axle assemblies
with bag heights of 12 in, 13 in, and 14 in respectively.
5. These weights are based on the axle and wheel equipment
weighing 1200 lbs ground weight with no (0 psi) air pressure.
Brakes
WARNING
Always check and maintain brakes in proper
condition and adjustment.
Out of adjustment
brakes could cause reduced braking ability and
result in property damage, personal injury, or
death.
Downhill Operation
WARNING
Do not attempt to gear down if the engine is
at or near maximum speed (RPM). Under these
conditions it will be impossible to shift into a
lower gear and could result in possible vehicle
runaway, resulting in property damage, personal
injury, or death.
Always descend hills with extreme care, relying primarily on the
engine braking effect to control vehicle speed. Heed warning
signs posted for any grade. Stop and check brakes for condition
and adjustment at available pull-off areas before starting a
descent.
Observe the following precautions:
•
Never coast downhill. Service brakes alone should not be
used to control speed on major downgrades. Brakes will
fade from overuse.
3879634R1
147
Summary of Contents for WorkStar Series
