SECTION 5 – MAINTENANCE SCHEDULE AND SERVICE PROCEDURES
Figure 32
Oil level gauge (typical)
14. Check oil level gauge.
Oil level must be within the
crosshatched operating range.
15. Start engine and run at low idle.
16. Check reading on oil pressure gauge.
•
Minimum lube oil pressure is 15 psi (103 kPa)
minimum @ 700 rpm.
•
If there is no gauge reading, shut engine down
immediately. Check for oil filter leaks.
•
Let engine run until operating temperature is reached.
Check for leaks.
17. Shut down engine for 15 minutes.
CAUTION
To prevent engine damage, do not overfill with oil.
18. Recheck oil level and add oil to bring oil level within the upper
half of the crosshatched operating range on oil level gauge.
CENTRIFUGE FILTER (IF EQUIPPED)
Service Interval (based upon fuel consumption and specific
engine application):
The centrifuge filter (if equipped) is located in one of the following
positions:
•
On the right side of the engine compartment.
It is
recommended to change the centrifuge filter every time
the engine oil filter is changed. For safety information,
refer to the your
Engine Operation and Maintenance
Manual
and
Vehicle Operator Manual
.
•
In the engine compartment. It is recommended to change
the centrifuge filter every time the engine oil and filter is
changed. See Engine Oil and Filter (page 65) for specific
service intervals. For safety information, refer to the your
Engine Operation and Maintenance Manual
and
Vehicle
Operator Manual
.
Page 69
Summary of Contents for MaxxForce 10
Page 8: ......
Page 10: ...FOREWORD Page 2...
Page 14: ...SAFETY INFORMATION Page 6...
