Page 24
DO
NOT
touch
hot
parts
and
AVOID
hot
exhaust
gases
.
Allow
equipment
to
cool
before
touching
.
Keep at least 5 feet (1.5 m) of clearance on all
sides of generator including overhead.
Replacement parts must be the same and
installed in the same position as the original
parts.
GENERATOR MAINTENANCE
Make certain that the generator is kept clean
and stored properly. Only operate the unit on
a flat, level surface in a clean, dry operating
environment.
DO NOT
expose the unit to
extreme conditions, excessive dust, dirt,
moisture or corrosive vapours.
DO NOT
use a garden hose to clean the generator.
Water can enter the generator through the cooling
slots and damage the generator windings.
Use a damp cloth to clean exterior surfaces of
the generator.
Use a soft bristle brush to remove dirt and oil.
Use an air compressor (25 PSI) to clear dirt and
debris from the generator.
Inspect all air vents and cooling slots to ensure
that they are clean and unobstructed.
•
•
•
•
CAUTION
Battery Replacement
English
1. Remove the spark plug wire from spark plug.
2. Remove the nut and bolt from the negative(-)
and po) posts.
3. Loosen and remove the screw A and nut B on
the battery holding bracket.
4. Remove the battery and recycle and dispose
of properly.
12V sealed lead acid 7.5AH
LXWXH:151X65X97mm(5.95X2.55X3.82inch)
5. Install the new battery with follwoing specification:
A(M6X12)
B(M6)
6. Connect the red po) battery cable to
the battery first.
7. Connect the black positive(-) battery cable
to the battery second.
8. Cover the post with boots.
9. Install the spark plug wire onto spark plug.
WARNING
ALWAYS
connect the positive (+) battery cable
(red boot) first when connecting battery cables.
ALWAYS
disconnect the negative (-) battery
cable (black boot) first when disconnecting
battery cables.
NEVER
connect the negative (-) battery cable
(black boot) to the positive (+) post on the
battery.
NEVER
connect the positive (+) battery cable
(red boot) to the negative (-) post on the battery.
NEVER
touch both battery posts simultaneously.
NEVER
place a metal tool across both battery
posts.
ALWAYS
use insulated or nonconducting tools
when installing the battery.
To avoid electric shock:
Summary of Contents for NG2500
Page 2: ......
Page 30: ...P N 323745451 Rev 01...
