12
WIFI 60FPS 1080P FHD
INSERTING THE MICRO SD CARD
Carefully push the memory card into the card slot, as shown in the diagram below (using your fingernail). The
Micro SD card will “click into place”. To take the memory card out, gently press the end of the memory card
inward using your fingernail until a click is heard. An internal spring will then release the card.
Note: This camera has no built-in memory. A memory card is needed for operation.
Note 2: High Definition and High Frame Rate video capture devices, place huge demands
on memory cards. Pending your user settings, it is recommended that a CLASS 10 SD Card
be used to avoid Read/Write complications, which will appear as an error message on the
screen during use. If you are not sure, please test any lower class cards (Read/Write speed)
in the device before use.
START-UP/SHUTDOWN
START-UP: Press and hold the power button until the Digital readout displays “ON”
Note: The remote control cannot turn the camera ON. You must use the power
button on the camera
SHUTDOWN: Press and hold the power button until the Digital readout displays “OFF”.
Note 1: The camera will automatically shut down after 5 minutes of inactive use to conserve power.
Note 2: If there is not enough power the low power battery icon will flash. When power has been exhausted
the camera will shutdown.
Note 3: The camera can be turned off with the remote control.
START RECORDING / TAKE PHOTO
When the camera is turned on, it will automatically enter video mode. Either select another mode or start
recording video by simply pressing the shutter button
Note: To stop video recording, press the shutter button again. When the memory card is full or the battery is
too low, the camera will also automatically stop recording.
CONNECTING TO A COMPUTER
Files can be played back directly from the Camera to a Windows ® Computer via a USB cable. The camera will
appear as a common removable disk under Window Explorer. (Drivers are not required)
