6.2
S/S Pan-head machine screw (M3 x 20)
2
6.3
S/S flat washer (M3)
2
6.4
S/S split washer (M3)
2
6.5
S/S hex nut (M3)
2
7
Warranty card
1
Wired Speaker with the following items:
No.
Description
# of items
1
SP100 Speaker
1
2
Speaker mounting box
1
3
AP-6 Accessory pack: Speaker kit
1
3.1
Speaker mounting gasket
1
3.2
Speaker bezels
2
4
AP-7 Accessory pack: Speaker mounting kit
1
4.1
S/S Pan-head self-tapping screw (M3 x 10)
4
4.2
S/S Pan-head self-tapping screw (M3 x 40)
4
4.3
S/S Pan-head machine screw (M3 x 20)
4
4.4
S/S Pan-head machine screw (M3 x 40)
4
4.5
S/S flat washer (M3)
4
4.6
S/S split washer (M3)
4
4.7
S/S hex nut (M3)
4
5
Warranty card
1
GPS-500 antenna with the following items (NRS-2 Systems only):
No.
Description
# of items
1
GPS-500 GPS antenna
1
2
See documentation provided in the GPS-500 box
Mounting guidelines
Choose the mounting location carefully, ensuring there are no hidden electrical wires or other parts
behind the panel before you drill or cut.
Ensure that any holes cut are in a safe position and will not weaken the boat’s structure. If in doubt,
consult a qualified boat builder
, or marine electronics installer.
¼
Note:
If more than one VHF antenna is installed, ensure adequate separation between antennas to
prevent antenna cross-talk. This may vary between installations and should be tested before mounting
locations ar
e confir
med. Mount units at least 50 cm (1.5 ft) away from a compass to avoid creating
magnetic deviation of the compass.
Don’ts:
•
Do not mount any part where it can be used as a hand hold, where it might be submerged, or where it
will interfere with the operation, launching, or retrieving of the boat.
•
Do not install in a hazardou
s or fl
ammable environment.
Do’s:
•
Mount to surface areas that are clean with no dirt, old paint, nor debris.
•
Mount units at least 1 m (3 ft) away from the VHF antenna.
| 49
Installation |
RS100 / RS100-B / V100 / V100-B User Manual
