JR, BM
04/07/14
NTV-DOC092
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
4 |
P a g e
Installation
1.
Access the main LCD screen by removing the panels surrounding it. This usually involves
pulling the panels and removing Torx screws.
2.
Remove the Volvo LCD by
removing the (4x) Torx T25 screws
that secure it into the dashboard
and disconnect all plugs connected
to the screen. Set the Screen aside
for now.
3.
The Volvo VIM kit includes (2x)
T-Harnesses. You must determine which is needed for your vehicle by examining the
CAN wires on the male side of the provided Power T-Harness:
4.
Plug the factory power/CAN harness into the female side of the supplied T-Harness.
5.
Plug the Volvo Cam module into the 18-pin connector located on the supplied T-
Harness. The LED on this module will light up solid whenever CAN is active in the car.
6.
Connect the male end of the supplied Plug and Play harness into the Volvo screen.
Reconnect the remaining plugs to the screen and test for proper operation before
reassembling dash.
Back of Volvo Screen
Compare the CAN wires on this plug with the factory Volvo screen’s plug: make
certain the wire locations match (are in the same position).
NTV-HAR207
NTV-HAR204
