BHM
11/11/16
NTV-DOC285
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 |
P a g e
Screen Removal and Interface Installation (Spark)
THIS INTERFACE INSTALLS AT THE RADIO (REMOVE SCREEN)!
1.
Remove the trim surrounding the main media
screen using plastic tools and set it aside.
2.
Remove (4x) 7mm screws securing the screen
assembly to the sub-dash. Disconnect all
connectors and set the screen aside.
3.
Locate the (gray & brown) OEM plugs connected
to the radio indicated here (right), and connect
the provided
T-Harness
portions of the
Power/CAN Harness
in between the car side and the radio.
4.
Connect the
OEM LVDS Video Cable
previously removed from the
screen
(not the radio)
to the port on the IOB-RVC interface labeled
‘VIDEO IN’ (use provided extension if
necessary)
.
5.
Connect the provided
LVDS Output Cable
from the
‘VIDEO OUT’
connector on the
module, directly to the screen LVDS Video
port. Make certain the connector is seated firmly.
6.
Connect the 12-pin white connector to the module at the port labeled
‘POWER CAN’.
7.
Connect your camera signal RCA to the yellow female RCA among the main power
harness labeled
‘CAMERA’
.
8.
The
purple wire
on the main power harness
outputs 12v (+) when in reverse only
(500mA max) and may be used for (single) camera power.
9.
The
green wire
on the main power harness is used to
force the rear cam or AV1 video
input RCA
(selectable – through OSD menu. See page 5 for menu options)
10.
The clear
4-pin molex
connector (from main power harness) is not used.
11.
Proceed to
IOB-RVC Operation
on page 4.
2017 Chevy Spark