BHM
10/04/18
NTV-DOC266
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
6 |
P a g e
•
If the vehicle possesses both
OEM
cameras (
reverse tailgate cam
on the rearview mirror and
cargo cam
on the
main 8.4” screen), force both cameras to display on the main 8.4” screen by completing the following:
a.
Extend
(splice, do not cut) the OEM tailgate signal with a
Single RCA cable (shield & signal)
to the main
radio location. There are two easily accessible locations for tapping this RVC signal:
*Note: If the OEM tailgate RVC signal is cut in half, the rearview-mirror image will display an error
while in reverse. SPLICE into these wires, DO NOT CUT!
b.
Connect your
extended tailgate signal (RCA)
from step 5.a. to the RCA labeled ‘
Cargo/Trailer CAM’
on
the 24-pin plug of the
SVS-6
module.
c.
Make sure you set
Cargo Cam
to
‘FIX’
(after first setting to ON and verifying the menu has been
emulated) in NAVTV Settings while programming the UCTv2.
Passenger’s side, behind
side dash panel
Driver’s side kick panel area
Green/Orange:
RVC (-)
Green/Brown:
RVC (+)
Green/Orange:
RVC (-)
Green/Brown:
RVC (+)
OR
This page is ONLY used for 2013-2015 RAM vehicles, when the user wants both OEM cameras (cargo & tailgate)
to display on the 8.4” screen (Cargo normally shows on mirror
). For 2016 RAM, continue to next page instead.
