79
9. Using a 6mm hex wrench, remove the indicated screws from the Motor
Mount. Remove the Drive Belt and rotate the Motor Assembly exposing
the Motor Mount.
10. Cut the 3 Zip-Ties that secure the Motor Cables.
11. Using a 6mm hex wrench, remove the indicated hardware from the
Motor Mount and remove the old Motor.
12. Attach the Motor Mount to the new Motor. Be sure the Belt Tensioner
Screw is properly oriented toward the rear of the machine when the Motor
is re-installed.
13. Lightly attach the Motor Assembly to the Frame. Be sure to only finger
tighten the hardware.
14. Loop the Drive Belt onto the Motor Pulley. With the Drive Belt looped
onto the Motor, carefully roll the Drive Belt onto the Drive Pulley.
15. Wrap the new Drive Belt around the Motor Pulley. Start the Drive Belt
on the Drive Pulley and roll it in a clockwise motion. Be sure the Belt does
not come off of the Motor Pulley.
Keep fingers out of any pinch opportunities when turning the
Pulleys.
16. Roll the Drive Pulley clockwise until the Drive Belt is fully installed.
Continue to roll the Belt forward while adding side pressure with fingers to
align as necessary.
Motor Cables
Zip-Tie
Motor Ground
Wire
Belt Tensioner Screw
Drive Belt
Motor
Mount
Motor
Pulley