54
NOTICE:
It is necessary to remove the Shrouds for this procedure. Refer to the “Replace the Shrouds” procedure.
It is necessary to adjust the Drive Belt tension at the end of this procedure. Refer to the “Belt Tension Adjustment” procedure
Note:
Your machine may not match the image. For reference only.
1.
Carefully remove the Shrouds. Refer to the “Replace the Shrouds”
procedure in this manual.
2.
Mark the position of the Belt Tensioner (A) on the Main Frame
bracket (D) to record the angle of the Tension Spring arm’s position.
3.
Slowly turn the Drive Pulley (B) backward and carefully ease the
Drive Belt (C) off the Drive Pulley to the outside.
Be sure to keep fingers clear of all pinch hazards as you
turn the Drive Pulley.
4.
Using needlenose pliers, release the Tension Spring (A1) from the
hook (H) on the Main Frame.
5.
Using 13 mm wrench and 6mm hex key, loosen and remove the Belt
Tensioner Hardware (E). Remove the Belt Tensioner assembly (A) from
the Main Frame and the Drive Belt (C). Discard the old Belt Tensioner
assembly.
6.
Install the new Belt Tensioner assembly. Adjust the Belt Tensioner
position to the angle of the previous position recorded in Step 2.
NOTICE:
Do not overtighten the hardware (E). The Belt Tensioner
must be able to pivot. If the hardware is too tight, this can
cause wear on the bearings.
7.
Put the Drive Belt (C) onto the Drive Pulley (B). Make sure the
Drive Belt is aligned on the Flywheel pulley (F), Belt Tensioner (A) and
Drive Pulley. Be sure that the upper portion of the Drive Belt is under the
bearings on the Belt Tensioner.
8.
Using needlenose pliers, attach the Belt Tensioner spring (A1). Make
sure that the belt tension is correct. Refer to the “Belt Tension Adjustment”
section in this manual.
Note:
This step may require two people.
9. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the wall outlet and wait 5
minutes before cleaning, maintaining or repairing this machine. Place the power cord in a secure location.
A
D
B
C
A1
H
E
A
C
F
B
A1