20
To reduce
the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the wall outlet and the
machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power cord in a secure location.
Note:
Your machine may not match the image. For reference only.
1.
Remove screws that attach Console to the Mast. Carefully lift the
Console off the Mast.
2.
Disconnect the Data Cable and Heart Rate Cable from the back of
the Console. Discard the Console and screws.
Note:
Do not let the cables fall down inside the Mast. This step may
require two people.
3.
Installation is the reverse procedure.
4.
Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the Owner’s
Manual.
Initial Setup
During the first power-up, the Console should be set up with the date,
time, your preferred measurement units and machine type.
1.
Date: Push the Increase/Decrease buttons to adjust the currently active
value (flashing). Push the Left/Right buttons to change which segment is
the currently active value (month / day / year).
2.
Push OK to set.
3.
Time: Push the Increase/Decrease buttons to adjust the currently active
value (flashing). Push the Left/Right buttons to change which segment is
the currently active value (hour / minute / AM or PM).
4.
Push OK to set.
5.
Units of Measurement: Push the Increase/Decrease buttons to adjust
between “MILES” (Imperial English) or “KM” (metric).
6.
Push OK to set.
7.
The Console display shows the Machine Type prompt with the current
setting. This menu option appears in the x624 series console only (not the
x626 series consoles). Push the Increase/Decrease buttons to change
between “BIKE” and Elliptical (“ELIP”).
8.
Push OK to set. The Console goes back to the Power-Up / Idle Mode
screen.
Note:
To adjust these selections, consult the “Console Service
Mode” section.
