![background image](http://html1.mh-extra.com/html/nautilus/be-strong-treadclimber-tc916/be-strong-treadclimber-tc916_assembly-manual_711751030.webp)
0
asseMbly InsTRUcTIons
Locate the following for this step:
Parts:
• assembly from step 1
hardware:
• 4 bolts (P/n 17683)
• 4 Lock Washers (P/n - 22222)
• 4 Washers (P/n 22091)
Tools:
• 3/4 inch socket for 1/2 drive
• Torque wrench (1/2 inch), set at 75 ft. lbs. (100 nm)
• 1/2 inch drive ratchet
2-1 on right side, connect handrail upright support
assembly to TreadClimber
®
base assembly using 2
bolts, 2 lock washers, and 2 washers. finger tighten
only, being careful not to pinch wiring harness. see
figure 2 and figure 2a.
2-2 repeat step 2-1 on the left side.
2-3 using the drive ratchet, tighten the 2 lower bolts on
each side first, and then the 2 upper bolts on each
side installed in step 2-1 and step 2-2. Then use the
Torque wrench to set the tightness for all 4 bolts to 75
ft. lbs. (100 nm)
imPorTanT!
Make sure that the wiring
harness cables Do not becoMe pincheD.
step2:connectinghandrailsupporttobaseassembly
figure 2: Connecting handrail support to base assembly
base
assembly
handrail upright support assembly
bolt
Lock Washer
Washer
figure 2a: Close-up of hardware stack.