14
Tools needed:
7/16 Socket
Ratchet
Moving Dolly
Lift Bar
step 1:
Remove TC916 from pallet by performing steps
in section “Removing Machine from Pallet” in
this manual.
step 2:
Tilt to 40 degrees (see Figure 1). While tilted
place 4-wheel moving dolly under center of
TreadClimber
®
frame (see Figure 2).
step 3:
Carefully, lower the TreadClimber
®
Model TC916
onto 4-wheel moving dolly (see Figure 3).
step 4:
Once in position in the facility, prepare to
remove unit from 4-wheel dolly by locking
castors.
MoVInG InsTRUcTIons
movingunitintoPositioninFacility
figure 1
figure 2
figure 3
figure 4
WHen loWeRInG THe TReaDclIMbeR
®
UnIT onTo Dolly be sURe THaT THe
casToRs aRe lockeD so THaT IT Does
noT MoVe oUT fRoM UnDeR THe
TReaDclIMbeR
®
UnIT.
7! 2 . ) . '
!4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .
noTe:
Perform the following moving procedure to position
your TreadClimber
®
Model TC916 in your facility if
your door ways are greater than 40 inches wide.