Service Manual Chapter7. Cash Dispenser Unit
© 2013
Nautilus Hyosung Inc.
All Rights Reserved.
7-50
Exit Shutter Adjustment
► Exit Shutter Adjustment
1. When joining the Solenoid Body and the Solenoid Bracket, tighten the screws at top
one place and bottom two places about halfway through, and then minimize the
distance between the Body and Bracket and fully fasten the screw.
2. When attaching the “Z” Assembly to the FRAME, insert “Y” Assembly to “Z”
Assembly, having them done horizontal with each other, and tighten the screw to the
full extent.
3. Adjust the distance between Y Assembly and Z Assembly to 7.8mm from the end of
Solenoid flanger C-clip to Solenoid Body.
<Warning!>
The ‘Y’ assembly value is supposed to become normal again by the spring. However,
it is important to check the “alignment” because problems can occur if the Flanger of
the Solenoid has not been connected horizontally.
