Current as of 2019-05-16
3.
Align the alignment index on zoom gear tube with the
red dot on the lens and insert the tube onto the lens.
4.
Align the spring ring with the lens as indicated in the
diagram. Then lightly push the ring towards the lens
until it cannot go any further.
Tip: To remove, pull out from the cover.
5.
Align the pins on the tube with the holes in the gear
ring as indicated in the diagram. Then tighten the
three screws.
6.
Align and tighten the screws with the Macro switch
block pressing on the lens MACRO button.
1.
screws.
7.
Align the inner groove of the macro switch gear with
the white dot on the front part of the lens. Then lightly
push the gear towards the lens until it cannot go any
further.
8.
Tighten the macro switch gear by screwing the
locking ring into the thread on the front of the lens.
9.
Align the positioning block onto the two gears. With
the longer ends inserted into the hole of the zoom
gear and the shorter ends sat into the groove of the
macro switch gear. Then tighten the two screws.
Repeat this with the other two blocks and check if
the lens can be switched between macro mode and
normal mode by turning the macro switch gear.
Repeat the above procedure if fail to switch.
10.
To un-mount, reverse the above steps.
*When mounting the Olympus 12-50mm EZ lens with the
gear on the GH5/EM1X camera, or when removing them,
the lens must be set to the “Macro” position.
