NAUTICA MARINE 200 User Manual Download Page 19

1. Remove the SEASCOOTER™ from the water.

2. Make sure the master switch is off.

3. Remove the battery - see page 16, step 1-9.

9. Replace the washer(s) and nut and tighten with the socket 

while holding the Propeller making sure it is securely 

fastened (See figure 20).

10. Replace the grille.

11. Replace the battery.

6. Slide the Propeller off the shaft, taking care not to loose the 

drive pin or washers.

7. Remove the blockage from the Propeller.

8. Replace the drive pin (if removed), see figure 19, and Propeller. 

Turn the Propeller slowly until you locate the pin and push 

the Propeller fully on.

4. Unscrew the six rear grille screws as shown in figure 17.

5. While holding the Propeller, use an M6 socket to remove the 

nut from the Propeller shaft (See figure 18).

For any questions or queries you may have regarding your 

SEASCOOTER™, please follow the below steps for easy and 

fast resolution:

- STEP 1-

Please read your User Manual. For a copy of the User Manuals, please visit 

www.Nauticaseascooters.com

- STEP 2-

Go to www.Nauticaseascooters.com and see our FAQ section to find instant 

answers.

- STEP 3-

Contact one of our Customer Service representatives at the Customer Service 

Center in your region.

CUSTOMER ENQUIRIES

If your unit is not operating, please refer to your User Manual before 

contacting our Customer Service Center. For any damage or repair work 

required, please do not return your product to the store where it was 

purchased.

RETURN / REPAIR POLICY

Customers must contact their Local Distributor Service Center to ask for an 

official Claim Form. The Claim Form must be returned with the customer’s 

contact details and a photo of the Seascooter, defective parts, the serial 

number and the Original Purchase Receipt. The Distributor Customer Service 

Center will review the case and issue a Return / Repair Authorization Number 

before sending the product to the Distributor Service Center. Returned 

products must be shipped with original packaging including the polystyrene 

packing material and all defective parts. Please contact your Local Distributor 

Service Center for assistance in handling your case.

Please visit our website www.Nauticaseascooters.com 

for a listing of  most update distributor contacts and 

ser vice center contacts.

RETURN / REPAIR PROCEDURE

1. Call the Customer Service Center for your Return / Repair Authorization 

Number. 

2. Make a copy of your Proof of Purchase (receipt). 
3. Pack the defective unit in its original packaging including the polystyrene 

foam and include the unit and all defective parts. 

4. Attach the copy of your Proof of Purchase (receipt) to the outside of the box 

(clearly visible), together with the Return / Repair Authorization Number.

5. Ship the package to the Service Center on your cost.

PLEASE NOTE:

 Deliveries that do not have the Proof of Purchase (receipt) 

and Return / Repair Authorization Number attached clearly to the outside of 

the box, will not be accepted by the Service Center.

In addition, this warranty does not cover items that 

experience normal wear and tear.

ALL IMPLIED WARRANTIES ARE LIMITED IN THE DURATION TO THE 

WARRANTY PERIOD. AND SUCH IMPLIED WARRANTIES INCLUDING 

MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR 

OTHERWISE, ARE DISCLAIMED IN THEIR ENTIRETY AFTER THE 

EXPIRATION OF THE APPROPRIATE WARRANTY PERIOD. THE 

DISTRIBUTOR’S OBLIGATION UNDER THE WARRANTY IS STRICTLY 

AND EXCLUSIVELY LIMITED TO THE REPAIR OR REPLACEMENT OF 

DEFECTIVE PARTS AND RETURN OF THE PRODUCT TO THE 

CUSTOMER. THE DISTRIBUTOR DOES NOT ASSUME OR AUTHORIZE 

ANYONE TO ASSUME FOR THEM ANY OTHER OBLIGATION.
THE DISTRIBUTOR ASSUMES NO RESPONSIBILITY FOR INCIDENTAL, 

CONSEQUENTIAL OR OTHER DAMAGES INCLUDING, BUT NOT LIMITED 

TO EXPENSE OF RETURNING THE PRODUCT TO THE DISTRIBUTOR, 

LOSS OF USE OF PRODUCT AND LOSS OF TIME OR INCONVENIENCE.

THIS PRODUCT IS DESIGNED AND INTENDED FOR PERSONAL 

RECREATIONAL USE ONLY!
THIS PRODUCT IS NOT WARRANTED FOR COMMERCIAL OR 

RENTAL USE!
REPAIR WORK OR DELIVERY OF A REPLACEMENT DOES NOT 

EXTEND OR RENEW THE WARRANTY PERIOD.
WARRANTY SHALL AUTOMATICALLY BE VOID IF DAMAGE IS 

RESULT OF NON-ORIGINAL PARTS.

LIMITED WARRANTY for Seascooters with camera mount:

• ALWAYS inspect to ensure the product works properly every time before 

use. Warranty of this product does not cover any damages due to misuse.

• Failure to follow the user(s) instructions on packaging and/or user(s) 

manual may result in damages or loss of your cameras including but not 

limited to any user’s personal items, all of which are not covered under 

warranty of this product.

• Use at your own risk. Manufacturer(s) and/or suppliers/agents are not 

responsible for any damages/repairs, loss to cameras/electronic items 

including but not limited to any user’s personal items directly and/or 

indirectly resulted in the use of this product. Damage(s) resulting from any 

use, misuse, accident, and normal wear and tear are understandably not 

covered under this product warranty nor be responsible by manufacturer(s) 

and/or suppliers/agents.

EXCLUSIONS

BATTERY. This warranty does not include the battery. 
Never replace the original SEASCOOTER BATTERY with an 

AFTERMARKET BATTERY. Seascooter with aftermarket battery will not be 

covered by this warranty.

Summary of Contents for MARINE 200




















Reviews: