Nautel XR12, Operation And Maintenance Manual

Page: 54 / 81

XR12 Operations and Maintenance Manual Operating the transmitter
Issue 3.1 2013-03-14 Page 2-29
Configuring NxLink (optional)
You can configure the NxLink Ethernet interface module, if installed, using the
NxLink
Configuration
page.
To view the
NxLink Configuration
page, select
Settings
from the
MAINMENU
page. Next, select
Hardware Settings
from the General Settings menu , then select
NxLink Configuration
from the
(only displayed if NxLink module is installed and communicating with the transmitter’s controller; the
screen should take less than one minute to appear).
Figure 2.23: NxLink Configuration page
To configure the NxLink, perform the following steps (see Figure 2.23 ):
1. Use the
Up
and
Down
buttons to select
IP Address
,
Netmask
,
Gateway
or
DNS Server.
DHCP’d Address
is not a selectable field. The address is automatically assigned when the
NxLink is connected to a LAN (if DHCP is available on the network and the IP Address is
set to 0.0.0.0 (as shown).
2. Press the
Edit
button on the highlighted address field to enable editing of the address. Press
the
Up
and
Down
buttons to move left to right through the address sections.
3. Press the
Back
button to exit address editing and press the
Save
button to save the NxLink
configuratiun.
10:18 0.00kW M-1 PM:AB Man Ex:A Man
NxLink Configuration
IP Address:
Netmask:
Gateway:
DNS Server:
DHCP’d Address:
Save Select Back
0. 0. 0. 0
255.255. 0. 0
192.163. 1. 2
192.168. 1.248
0. 0. 0. 0
10:18 0.00kW M-1 PM:AB Man Ex:A Man
NxLink Configuration
IP Address:
Netmask:
Gateway:
DNS Server:
DHCP’d Address:
Save Select Back
0. 0. 0. 0
255.255. 0. 0
192.163. 1. 2
192.168. 1.248
0. 0. 0. 0