Nautel VS300, Installation Manual

Page: 19 / 48

VS300 Installation Manual Installing program inputs
Issue 6.0 2014-11-01 Page 6-1
Section 6: Installing program inputs
This section describes how to connect program input wiring to the VS300.
Planning
Make sure you have read and fully understood the program input options described in the VS300 Pre-
installation Manual before proceeding. The VS300 Pre-installation Manual also includes the connector
type and gender (male or female) of the transmitter’s interfacing connectors.
Connecting cables
1. Obtain a ferrite toroid [85.7 mm (Nautel Part # LP23) or 38 mm (Nautel part # LXP38), as
appropriate] from the Installation Kit.
2. Route program input cable(s) through the ferrite toroid, then to the rear of the VS300. If
practical, pass the cable through the ferrite toroid twice (two turns).
3. Connect the appropriate program input cable(s) between the program source(s) and the
connector(s) described in “Analog inputs” or “Digital inputs” in the VS300 Pre-installation
Manual (see
Figure 6.1 on page 6-2 ).
Note:
With the exception of D-sub connectors, all program input mating connectors must be provided by
the user.