Nautel NV15LT, Installation Manual

Page: 19 / 78

NV20LT/NV15LT INSTALLATION MANUAL INSTALLING OPTIONS
VERSION 4.0 2018-02-26 PAGE 2.3.1
SECTION 2.3: INSTALLING OPTIONS
The NV20LT/NV15LT transmitter is factory configured and shipped to operate with the customer’s
desired ac power source voltage and RF output connector size. There are options available for various
other features, including dual exciter, UPS interface, redundant LVPS, and remote interfacing. These
options may be installed in one of two ways:
 You install and configure options at your site, using kits and instructions provided by Nautel.
Each option has a separate kit.
 Pre-arrange for Nautel to install and configure options at the factory prior to shipping.
Table 2.3.1 shows the standard (default) configuration of the NV20LT/NV15LT, as well as the available
options. Each option references a recommended schedule of installation and the procedure (or
associated document) that describes how to install and configure the option. Review the options in
Table 2.3.1 to determine which, if any, apply to your installation.
If you did not purchase any options for your NV20LT/NV15LT and intend to operate with the standard
(default) configuration, proceed to
Section 2.4, “Connecting to Station Reference Ground” .
NOTE
: When an option is installed (UPS interface, dual exciter, etc.), the extra parts removed (e.g.,
blank exciter panel, AC LED cover) from the original configuration are placed in the Ancillary kit.