Nautel NV10LT, Installation Manual

Page: 35 / 70

NV10LT/NV7.5LT INSTALLATION MANUAL INSTALLING PROGRAM INPUTS
VERSION 5.0 2021-03-01 PAGE 2.7.3
Figure 2.7.2: Routing Program Input Cables
** PROGRAM INPUT WIRING ENTRY HOLE HAS A REMOVEABLE PLATE WITH A PRE-CUT
1/4-INCH DIA HOLE. USE A CHASSIS PUNCH TOOL (e.g., GREENLEE) TO CREATE DESIRED
HOLE SIZE IN THE PLATE. REMOVE PLATE (FOUR M4 SCREWS) BEFORE PUNCHING.
PROGRAM INPUT
ENTRY **
CHANNEL
ENTRY POINT
CHANNEL
EXIT POINT
TYRAP ANCHOR
HOLES PROVIDED
FOR ROUTING
WIRE OUTSIDE OF
CHANNEL
CONNECT TO REAR PANEL
OF CONTROLLER (EXCITER
A) AND OPTIONAL EXCITER
B. See Pre-Installation Manual
for details)
REMOVE THE PLATE TO ACCESS A 2.5-INCH HOLE, IF NECESSARY.
CONTROLLER
(EXCITER A)
EXCITER B
(OPTIONAL)
SHOWN WITH DUAL EXCITERS