23
22
3.4 Deactivating the opening delay
You can only change the opening delay during the opening window.
Step
Action
Key
1.
Enter the user or master code, for example 5678913
5678913
2.
The opening delay time starts, the red light illuminates every
few seconds
3.
When the opening delay has elapsed, you will hear an audible
signal and the opening window begins. The light illuminates
every few seconds.
4.
Press and hold the ‘9’ button until the red light stays on
9
5.
Key in the master code, for example 5678913
5678913
6.
Key in 00 (= 0 minutes) to deactivate the opening delay
00
7.
Key in 01 to deactivate opening window
01
8.
Repeat 00 to deactivate the opening delay
00
9.
Repeat 01 to deactivate opening window.
The opening delay is now disabled.
01
3.5 Skipping the delayed opening (instant opening code)
If the safe has a delayed opening, it is still possible to gain immediate access. The code for user number 9 is also
a special instant opening code. You must, of course, create user number 9 beforehand (see 2.2). Please note that
the code for user number 9 must not be the same as the master code.
Step
Action
Key
1.
Enter the user or master code, for example 5678913
5678913
2.
The opening delay time starts, the red lamp light up every few
seconds
3.
Key in the code of user 9 for instant opening of the lock, for
example 9191911
9191911
4.
If you turn the handle within 3 seconds, you can access the safe
without having to wait for the delayed opening.
4. Silent alarm
4.1 Opening with alarm code
The lock opens normally after entering the alarm code. Simultaneously a relay is triggered by which the alarm
code can be signalled to a burglar alarm system. Alarm code: the number to be added to the last number of the
code. Usually this is 1.
If the result becomes double-digit, only the last number is taken (e.g. 9+1=10, enter only 0).
If the sum ends in two digits, you only need to enter the last digit. For example: your code is 3456789. The last
digit is 9+1 = 10. In this case, you enter ‘0’ as the last digit.
5.1 Temporary block / unblocking all users
You can use the master code to temporarily block all users, and you can use the same procedure to unblock
them again. Their programmed user codes will then be valid again.
Step
Action
Key
1.
Press and hold the ‘2’ button until the red light stays on
2
2.
Enter the master code, for example, 5678913
5678913
5. Blocking / unblocking
Once all the user codes have been blocked, the safe can only be opened with the master code.
Please note, if the user codes are to be used again, they must be unblocked with the master code first
6.1 User overview
This function allows you to see which ID numbers are in use and which are still free. Their user codes can only be
checked with the master code, however. If there is just one sound, then the ID number is still free or non-active. If
the sound is made twice, then the ID number is in use or the user is active.
Step
Action
Key
1.
Press and hold the ‘7’ button until the red light stays on
7
2.
Enter the master code, for example, 5678913, and the red light
goes out
5678913
3.
Enter the ID number of the user you want to check,
for example 2
02
(FREE)
(OCCUPIED)
4.
Enter 0 to stop
0
6. Overview
Step
Action
Key
1.
Enter the user or master code, e.g. 567891
3+1
567891
4
2.
Turn the handle within 3 seconds into opening position, the lock
is opened
USER MANUAL ELECTRONIC LOCK MULTICODE
