Cabling the Components
July 14, 2016
3-5
Mounting the ErgoJust cart video pole
It is recommended that this operation by performed by two persons to avoid injury or damage to
the equipment.
1. If necessary, loosen the four video pole mounting screws sufficiently to allow the video pole to
insert into the bottom mast (Figure 1). Do NOT remove the screws or loosen the screws too
far!
2. Using an assistant, lower the video pole into the bottom mast until fully seated.
3. Tighten all four video pole mounting screws (Figure 2).
NOTE:
If the mounting screws are loosened too far during this procedure, the mounting plate(s)
may fall loose. Ensure they are reinstalled with the
convex
side of the plate pointing inward toward
the bottom mast BEFORE mounting the video pole (Figure 3).
Figure 3: Video pole mount plates orientation.
Figure 1: Loosen all four video pole
mounting screws. Do NOT remove screws.
Figure 2: Insert the video pole and tighten
all four video pole mounting screws.
