Mounting the Components
July 14, 2016
2-3
Adjusting the Natus ErgoJust cart components
The Natus ErgoJust cart work, keyboard and monitor may be adjusted to use in sitting or standing
positions. Adjust the height of these components to a comfortable position to minimize strain on
the arms, wrists, neck and eyes. The monitor and keyboard tray can further be tilted forward and
backward according to individual user preference.
It is recommended that you first adjust the keyboard tray to desired position and then the monitor.
NOTE
: Once the cart has been positioned at the desired location, lock all four caster wheels in
place before using it.
Locking/unlocking the
wheels
1. Raise the locking levers (Figure 1) on all four wheels to transport the ErgoJust cart.
2. Lower the locking levers on all four wheels to lock the ErgoJust cart in place.
Figure 1: Locking/unlocking the wheels.
Transporting the
ErgoJust cart
1. Push the display monitor down to the lowest position.
2. Disconnect the power cord from the ISO or UPS and secure the cord to the cart.
3. Unlock the casters and point the casters in the direction of travel.
4. Use the rear handle to push the cart using both hands.
NOTE:
If there is a photic stimulator mounted on the cart, swivel the arm and secure it close to the
cart pole to avoid damage during transport.
Adjusting the work
surface height
1. Place your hands below the work surface and lift slowly upward to raise the work surface.
(Figure 2).
2. Place your hands on top of the work surface and push slowly downward to lower the work
surface.
Figure 2: Adjusting the work surface height.
