https://www.naturewater.eu
Item 63924
Page 17
01 2024-1
of water is added to the brine tank so that the appliance has ready-to-use brine available for the
next regeneration. Once refilling is complete, the system switches to the quick-rinse option, in
which it takes around 5
min for the discharge to be recognised. Once the hardness has been
determined, proceed to the next step and return to the operating option to produce softened
water.
4.
Salt addition to the brine tank and salt addition process
Open the lid and pour a sufficient amount of soaked salt into the brine container. The salt in the
brine tank must be above the water level. As a rule, the salt should exceed the level of the water
in the brine tank and salt particles should always be visible.
Water level
№
Description
№
Name
1
Salt content lower than water level (add salt)
2
After adding salt (salt level above water
level – close salt drawer)
5.
First complete regeneration
Once the above steps have been completed, the water softener must stand for 6 hours so that
the salt particles filled into the brine tank can dissolve sufficiently and a sufficiently concentrated
brine is produced. In the unlocked state, press to start regeneration so that the system runs
automatically and performs a complete regeneration. During this process, the water and elec-
tricity must not be switched off and no buttons must be pressed.
6.
First use
After 5
min of drawing water from the tap, the softened water can be used normally.
