Page 7 / 31
provide room air accordingly. Limited air for combustion may result in poor performance, smoking and other
side effects of poor combustion.
If you have any questions with regards to your stove or the above-mentioned information, contact
your dealer for further clarification.
SINCE STOVE SUPPLIER HAS NO CONTROL OVER THE INSTALLATION OF YOUR STOVE,
STOVE SUPPLIER GRANTS NO WARRANTY IMPLIED OR STATED FOR THE INSTALLATION,
MAINTENANCE OR PERFORMANCE OF YOUR STOVE AND THEREFORE ASSUMES NO
RESPONSIBILITY FOR ANY CONSEQUENTIAL DAMAGE(S).
AUTOMATIC SAFETY FEATURES:
Your pellet stove has the following safety features:
A.
The exhaust blower will shut down once exhaust temperatures drop below 125°F (52°C).
B.
The stove has a high temperature safety switch near the hopper. If the temperature reaches 200°F (93°C),
the auger will automatically stop and will stay shut down. Once the blowers shut down, toggle the rear power
switch to reset.
C.
If the hopper lid or the front cover is opened when the unit is running, the vacuum switch will cause the
auger to automatically stop.
D.
If the power goes out, the unit will stop running. When the power comes back on, the stove will not restart
unless the exhaust temperature is still above 125°F (52 °C).
PRODUCT INFORMATION:
The NC-40 Pellet stove is an advanced design that utilizes individual fresh air intake and venting pipes.
Negative pressure burning technology creates high efficiency burning with very little ash in the exhaust. State
of the art controls shut off the unit automatically if operated incorrectly or if out of pellets.
Model
NC-40
Rated input BTU/h
45,000
Rating fuel consumption low/med/high lb/h
3.3/4.2/4.84 lb/h +/-5%
Heating area Feet²
~1600
Rating voltage Volts
115
Rating frequency Hz
60
Rating power Watts/Amps
<
=
150/4.5
Hopper Capacity pounds
55
Venting pipe diameter Inch
3
Air input pipe diameter Inch
2
Unit size (wide x depth x height) Inch
26.75 x 25.5 x 39
Wood pellets
This stove uses wood pellet fuel only which is usually 0.2-0.3 inches in diameter with a length of 0.5-1.5
inches. The moisture content must be 10% or lower and the ash content no more than 3%. Use proper care
with pellet fuel. Do not moisten or crush the pellets as this will affect the efficiency and dust will collect on the
door glass. Store pellets outside of clearance to combustible requirements and in a dry place.
Summary of Contents for NC-40
Page 9: ...Page 9 31 VENT TERMINATION LOCATIONS ...
Page 11: ...Page 11 31 ...
Page 26: ...Page 26 31 ...