NRC-6-SV
Room Thermostat and Remote Control Module
For a clearer distinction between different boiler’s states (
On/Standby
), the middle section of
the screen has a different view. While the burner is in
Standby mode
, there will be no
indication on the screen. If the burner was working before switching it to “
Standby
”, an
extinguishing process for the fire will start to take process. Keep in mind, that it will take
some time for the fire to be completely put out and after that some more time for the cleaning
procedure to be complete. It is normal for the burner’s and boiler’s aggregates to continue
operating for a certain time during the
Standby mode
. When the burner is turned on, the
screen will change and a “
Fuel type
” field and boiler’s temperature field will appear. The
burner will proceed to an automatic ignition start if all the necessary conditions for the
burner's ignition are fulfilled: the temperature of the boiler is lower than the set temperature,
the room thermostat and the OD input for forced stop are not activated, and if there are no
registered serious errors.
While on
Timers mode
, the burner will work only during the time intervals when its work is
allowed. These time intervals can be set from the menu option
Timers
in the
User Settings
.
If
Timers mode
is selected, but there are no active timers set, the burner remains in
Standby
mode
and a warning message will displayed on the screen (message is shown in the figure
below). The controller will save the chosen mode and
as soon as any of the timers are
activated, the burner will switch to
Timers mode
automatically, without having to select it
again.
p.9 /21
