11
aluminium
frame
line
terminal box
ZP 01
aluminium
frame
line
EN Instructions for assembly
See the picture below.
5. You measured the pitch of the holes for screws. Now you mark them as the intersection points on the horizontal line on the wall that you already
drew. Every intersection point is ½ of the measured pitch distant from the marked centre (½ X). Check one more time if the total distance between
intersection points on the wall (Y) corresponds with pitch of the holes on the mirror (X).
6. Drill the holes to the marked intersection points. Use the correct drill and attachment components according to the type of wall material!
If the base is suitable (it is the standard brick wall with standard plaster thickness) you can use wall plugs and screws included in the package.
Put the wall plugs in the drilled holes and use the screws whereas their head and shank stick out (max 5 mm of the visible shank).
7. Connect the connecting cable with the mains cable or junction box. It is recommended to work in a pair! For connecting the cables, you can use
the terminal box of article number ZP01 (in the picture) or any other terminal box with the suitable IP for bathroom furnishing. Before you start
connecting the cables, make sure there is no electric power in the supply cable! Connect the cable of the mirror to the electric power supply to
conductors L, N and PE. Terminal box is not included in the package. Use only recommended supply voltage 230 V AC, 50 Hz, L+N+PE with front
fuse max. 16 A.
aluminium
frame
line
