10
aluminium frame line
glass
aluminium
frame
min 40cm
above the upper edge
of the basin
Zone 1
Zone 2
Zone 0
225cm
EN Instructions for assembly
Follow the instructions for assembly.
Do not install in the zones 0+1+2
1. Firstly, prepare the final position of the mirror. The optimal way for choosing the right position is to place the mirror on the required place on the
wall and see if that suits you.
2. With help of the other person mark the upper edge of aluminium frame on the wall. Do not mark the edge of the mirror! (Aluminium frame of
some mirror models is of a different size than glass of the mirror!). Draw a small horizontal line. See the picture below.
3. 60 mm under the line draw another line and using the water-level draw this line in a size of the mirror width. Doing this you measured the height
of the holes for screws (their horizontal position).
Mark the centre which you can measure by the sink or tap.
4. Now it is important to know the screw pitch, their vertical position. (NIMCO offers a wide range of models and types of mirrors of different size.
This general manual does not indicate the pitch for each model. It is then important to measure it.) The pitch is measured directly on the mirror. On
the back side of the mirror there are holes in the aluminium frame for vertical or horizontal attachment. (Warning! It is possible to attach the mirror
horizontally or vertically.). Choose the correct holes according to your choice. These are the round holes. Measure their pitch, the distance of their
centre lines (x).
Side view - basin
Side view - bath
