Page of 7
4
•
Do not modify the product
in any way.
Unauthorized modification may impair the function and/or safety and
could affect the life of the equipment. There are specific applications for which the product was designed.
•
Always check of damaged or worn out parts before using the product.
Broken parts will affect the products
operation. Replace or repair damaged or worn parts immediately.
•
Store idle product.
When the product is not in use, store it in a secure place out of the reach of children.
Inspect it for good working condition prior to storage and before re-use.
1.
INSTALLATION
1)
The “Solar Sensor Light” should be set up at a location where you desire to have extra lighting to detect
persons or objects moving at night or in the dark.
2)
Decide where you want to place the Lamp(1) and Solar panel(2). The Light is equipped with 5 meter
connecting wire, so the Lamp(1) and Solar panel(2) can be installed up to 5 meters apart.
3)
The Solar panel(2) must be set in a location that receives full, direct sunlight a minimum of 8 hours a day.
So we advise putting it on a wall or roof.
4)
Mount the Lamp(1) 2 to 3 meter above ground on a solid surface capable of supporting the Lamp(1) and
secure enough so that it will not move when exposed to vibration or wind. The unit must be high
enough to allow for motion detection and light distribution.
5)
Using the Mounting Plate as a template, mark certain that the drilling path is clear of obstacles such as
cable and electrical line. Place Mounting Bracket(13) on drilled holes and thread in the enclosed
Mounting Screws to secure Mounting Bracket in position.
6)
Install the Solar Panel(2) in the same way that you installed the Lamp(1) in steps 4 and 5.
7)
Carefully route the power Cord of the Solar Panel(2) to the Lamp(1) and plug it into the battery housing
outlet(8).
8)
Adjust the Motion Detector Head(6) below the light by moving it left or right so that it faces the area
where movement will occur. Move it up or down by using the screw located on the neck of motion
Detector Head(6).
OPERATION
• Before the Solar Sensor Light can operate to its full capacity, the Solar Panel needs to be in sunlight
for 3 days to fully charge the battery. Turn the Switch to the “OFF” position. After charge, turn the switch
to “AUTO” or “ON” position.
• Turn the switch to “AUTO” position, the light will turn on automatically at night when motion is
detected by the Motion Detector Head(6).
• Turn the switch to “ON” position, the light can be used as a standard light.
