Native TCT User Guide-v1.0
Figure 3-24: GPS
Note: If the GPS information is unavailable for 6 minutes, the process fails.
4.2.1.4.
Bluetooth LE
This section describes the Bluetooth LE testing options. If the functionality works as
expected, press PASS, otherwise, press FAIL.
Gatt Client Test
To perform the test
a.
Make sure Bluetooth is turned ON.
b.
Run
Gatt Server
from TBT module list in another device.
c.
Press
Discover
Button to start discovering Gatt Server.
d.
Select
Gatt server ID
from discovered list to connect it.
e.
After successfully connected, two services
Link loss service
and
Battery service
will be shown.
f.
select
Link loss
service, a characteristic will be shown
g.
Select characteristic, then press Read button.
Get
value will be shown and
Read
request will be
shown in Gatt Server end.
h.
Press
Write
button, value written to Gatt Server and it will be shown there.
i.
Press
hardware back
button,
services
list will be shown again
j.
Select
Battery
service, a characteristic will be shown
k.
Select characteristic, then press
Read
button.
Get
value will be shown and
Read
request will be
shown in
Gatt Server
end.
l.
Press Expand button,
Descriptor
list will be shown under battery characteristic.
m.
Select descriptor then press Read button,
Get
value will be shown and
Read
request will be shown
in
Gatt Server
end.
n.
Press
Write
button, value written
to Gatt Server
and it will be shown there.
o.
Press
HW Back
button, services list will be shown again
p.
Select
Battery service
, a characteristic will be shown
q.
Press
Notify
button at
Gatt Server
end, changed value will be shown in
Gatt Client
end.
r.
Press
Disconnect
button to Disconnect from Server.