If you have any questions concerning these instructions, please call National Customer Service
800.482.1717
.
Assembly Instruction
1610 Royal Street
Jasper, Indiana 47546
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
3248959
Rev, B
LOCHLYN
FREESTANDING FRAME
BUILD
2
TOOLS REQUIRED
IMPACT DRIVER OR DRILL DRIVER
#2 PHILLIPS BIT
TOOLS REQ. (FLOOR ANCHORING)
HAMMER DRILL
DRILL DRIVER
TOOLS REQ. (WALL ANCHORING)
IMPACT DRIVER OR DRILL DRIVER
9/64”
DRILL BIT
HARDWARE
M4 X 12MM THREAD FORMING
SCREWS
QTY VARIES BY MODEL
JUNCTION BLOCKS
QTY VARIES BY MODEL
PLASTIC CAPS
QTY VARIES BY MODEL
HARDWARE (FLOOR ANCHORING)
SEE PG. 8 FOR RECOMMENDATIONS
HARDWARE (WALL ANCHORING)
M4 X 12MM THREAD FORMING
SCREWS
QTY VARIES BY MODEL
STEEL 90 DEGREE BRACKETS
QTY VARIES BY MODEL
3/16”
X
11”
FLAT NYLON STRAP
QTY VARIES BY MODEL
SEE PG. 10 FOR WALL FASTENER
RECOMMENDATIONS
1
Unpack frame sub
-
assembly sections and spread out for access and identification in
the later steps of assembly
(Figure A).
Model Assembly Instruction Sheet
(“
Model AI Sheet
”)
includes frame dimension references and parts list for
specific model.
2
Select a frame sub
-
assembly and move to work area.
Lay the assembly horizontally on the worksurface. Note
the 3
-
hole pattern features
(Figure B)
at the different levels.
Retrieve the junction blocks
(Figure C)
and position one at
each 3
-
hole pattern so that the protruding features (bosses)
engage the upper and lower hole of each pattern (
Figure D
).
The protruding (boss) features will be a press fit into the
holes.
FIGURE B
3
Retrieve the pack of screws from the hardware
kit. At each junction block, start and tighten a
screw through the cavity in the junction block
(Figure
D)
and into the frame. This will secure the block to the
vertical frame section.
CAUTION:
An impact driver may be used but
excessive driving can strip the threads in the frame.
Stop driving immediately after there
’
s audible impacts
to avoid stripping the screws. If a drill driver is used, a
lower clutch setting should be used to avoid stripping
the screws.
FIGURE A
FIGURE C
FIGURE D
bosses
