National ramp Liberty Series, Installation Manual

Page: 115 / 138

20.11.4.
Orient the bracket according to the configuration being installed, taking special note of
the tongue and groove orientation.
20.11.5.
Rotate the bracket about 30° to insert into the section side channel.
20.11.6.
Fasten bracket into the side channel using driller screws (pre-drill to ease installation),
confirming the bracket holes to be used per the chart.
20.11.7.
Pull/push up on the tongue side of the section to verify the bracket install. A successful
install will not allow the tongue to disengage from the groove.
20.11.8.
Place all leg caps, corner guards and end caps needed.
A A
B B
C C
D D
E E
F F
1
1
OF NATIONAL RAMP.
1. FOOT PLACEMENT DIMENSIONS MUST BE VERIFIED BASED ON FIELD CONDITIONS AND ACTUAL INSTALL
A A
B B
C C
D D
E E
F F
1
1
OF NATIONAL RAMP.
1. FOOT PLACEMENT DIMENSIONS MUST BE VERIFIED BASED ON FIELD CONDITIONS AND ACTUAL INSTALL
1 3
2
4
A A
B B
C C
D D
E E
F F
1
1
OF NATIONAL RAMP.
1. FOOT PLACEMENT DIMENSIONS MUST BE VERIFIED BASED ON FIELD CONDITIONS AND ACTUAL INSTALL
End Caps
Leg Caps
Corner Guards
[ 115 ]
Liberty Series™ Ramp Installation Guide-Revision 8/1/2020
image 108
image 109
TW
O LA
Y
OUT C
ONFIGURA
TIONS S
T
AR
T T
O FINISH