National Instruments WSN-3230, User Manual And Specifications

Page: 15 / 35

© National Instruments Corporation 15 NI WSN-3230/3231 User Guide and Specifications
Signal Strength/Status LED Indicators
The NI WSN-3230/3231 has four signal strength/status LED indicators, which flash twice before
displaying signal strength information. Table 1 shows the status and signal strength LED patterns.
Table 1.
Signal Strength and Status LED State/Node Status
LED Indication
Mode LED State LED Pattern Device Status
Signal Strength—
LEDS 1–4 blink
twice and then
display the signal
strength for three
seconds LED 1–4 OFF Low Signal
LED 1 ON,
LED 2–4 OFF Poor
LED 1–2 ON,
LED 3–4 OFF Fair
LED 1–3 ON,
LED 4 OFF Good
LED 1–4 ON Excellent
Status Indication Each LED 1–4
blinking in
succession Searching for a network
LED 1, 4 and 2, 3
alternate blinking Updating firmware
LED 1–4
continuously
blinking Error. Reboot device. If problem
persists, reset device to factory
default settings. Go to
ni.com/
support
for additional
troubleshooting steps.
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4 1 2 3 4
1 2 3 4 1 2 3 4
1 2 3 4 1 2 3 4
1 2 3 4 1 2 3 4