Appendix A
Default Settings
A-2
ni.com
Table A-2.
VXIpc 870 Series Hardware Default Settings
Jumper
Default Setting
Optional Setting
J12
Enable automatic Slot 0 detection
Force Slot 0; Force Non-Slot 0
S1
MITE user configuration
MITE factory configuration
S2
Enable MITE self-configuration
Disable MITE self-configuration
W1, 3, 5, 7
CPU bus factor
Note:
For more information, refer to
the
VXIpc 870 Series User Manual
.
W4
100 MHz CPU bus speed
66 MHz CPU bus speed
W6
Normal CMOS operation
Clear CMOS
W8
Flash write enable
Flash protection
W10
Enable Ethernet Serial EEPROM
configuration
Disable Ethernet Serial EEPROM
configuration (uses default power on
values)
W11–12
Enable 16-bit SCSI termination
SCSI termination
W15
Voltage monitor only required voltages
Voltage monitor all voltages
Table A-3.
VXIpc 850/860 Hardware Default Settings
Hardware Component
Default Setting
S1—Ethernet EEPROM
Enabled.
Do not alter this setting
.
S2—Power On Self-Configuration (POSC)
Enabled.
Do not alter this setting
.
S3—CLK10 Source
Source from onboard oscillator
S4—CLK10 SMB Polarity
Not inverted
S5—CLK10 SMB Direction
Receive CLK10
S6—CLK10 SMB Termination
Do not terminate
S7—TrigIn SMB Termination
Do not terminate
S8—GPIB Circuitry Interrupt
Level 11
S9—MITE Configuration EEPROM
Load values from user section
