![background image](http://html1.mh-extra.com/html/national-instruments/vision-cvs-1455/vision-cvs-1455_user-manual_3429982057.webp)
Appendix A
Troubleshooting
©
National Instruments Corporation
A-5
NI CVS-1450 Series User Manual
LED Error Indications
The NI CVS-1450 device indicates specific error conditions by flashing the
orange
STATUS
LED a specific number of times. Table A-1 describes the
STATUS
LED flashing sequences and the corresponding error condition.
POWER OK LED Is Not Lit When the NI CVS-1450
Device is Powered On
If the power supply is properly connected to the NI CVS-1450 device, but
the
POWER OK
LED does not light up, check that the power supply is
24 VDC ±10% and within the specifications outlined in
Getting Started
with the NI CVS-1450 Series Compact Vision System
. Using a power
supply that is not within these specifications might result in an
unresponsive or unstable system and could damage the NI CVS-1450
device.
Table A-1.
STATUS LED Flashes and Corresponding Error Conditions
Number
of Flashes
Error Condition
0 (stays lit)
The NI CVS-1450 device has detected an internal error.
Contact National Instruments for assistance.
1
The NI CVS-1450 device is unconfigured.
2
The NI CVS-1450 device has detected an error in its
software. This usually occurs when an attempt to
upgrade the firmware is interrupted. Repeat the
firmware upgrade process.
3
The NI CVS-1450 device is in safe mode.
4 (or more)
The NI CVS-1450 device has detected an
unrecoverable error. Contact National Instruments for
assistance.
Summary of Contents for Vision CVS-1455
Page 1: ...CVS 1455...