Table 4. Connector Descriptions
Connector
Use
RF 0 TX1 RX1 Input and output terminal for the RF signal. TX1 RX1 is an SMA (f)
connector with an impedance of 50 Ω and is a single-ended input or output
channel.
RX2
Input terminal for the RF signal. RX2 is an SMA (f) connector with an
impedance of 50 Ω and is a single-ended input channel.
AUX I/O
General-purpose I/O (GPIO) port. AUX I/O is controlled by the FPGA.
RF 1 TX1 RX1 Input and output terminal for the RF signal. TX1 RX1 is an SMA (f)
connector with an impedance of 50 Ω and is a single-ended input or output
channel.
RX2
Input terminal for the RF signal. RX2 is an SMA (f) connector with an
impedance of 50 Ω and is a single-ended input channel.
DP
DisplayPort connector to connect one monitor for your controller.
USB2.0
USB ports that support common USB peripheral devices such as flash
drives, hard drives, keyboards, and mice.
USB3.0
USB ports that support common USB peripheral devices such as flash
drives, hard drives, keyboards, and mice.
1G ETH
RJ45 port used for 1G ETH connectivity to other ethernet devices.
μUSB
USB port used for UART connectivity to the controller.
1G/10G ETH 0 SFP+ port used for 10G ETH connectivity to other ethernet devices.
Connects to the embedded Linux computer for communication with
LabVIEW RT.
1G/10G ETH 1 SFP+ port used for 1G/10G ETH connectivity to other ethernet devices.
Connects to the FPGA. Not currently supported in LabVIEW
Communications System Design Suite.
12
|
ni.com
|
USRP-2974 Getting Started Guide