1.
Verify that your device is powered on and connected to your computer using the gigabit
Ethernet interface.
2.
Select
Start
»
All Programs
»
National Instruments
»
NI-USRP
»
NI-USRP
Configuration Utility
to open the NI-USRP Configuration Utility.
3.
Select the
Change IP Address
tab of the utility.
Your device should appear in the list on the left side of the tab.
4.
In the list, select the device for which you want the change the IP address.
If you have multiple devices, verify that you selected the correct device.
The IP address of the selected device displays in the
Selected IP Address
textbox.
5.
Enter the new IP address for the device in the
New IP Address
textbox.
The utility should appear similar to the following figure.
Figure 1. Changing the IP Address
6.
Click the
Change IP Address
button or press <Enter> to change the IP address.
The IP address of the selected device displays in the
Selected IP Address
textbox.
7.
The utility prompts you to confirm your selection. Click
OK
if your selection is correct;
otherwise, click
Cancel
.
8.
The utility displays a confirmation to indicate the process is complete. Click
OK
.
9.
Power cycle the device to apply the changes.
NI USRP-29xx Getting Started Guide
|
© National Instruments
|
9