Chapter 2
System Setup
©
National Instruments Corporation
2-3
TPC-2206/TPC-2212/TPC-2215 User Manual
Caution
Be sure system power is off before plugging in or pulling out the CompactFlash
card.
2.
Verify that the CompactFlash card containing Windows Embedded or
another operating system is installed in the unit.
3.
Connect the power connector to an 18–32 VDC power line. Be sure to
connect the positive, negative, and ground lines as shown in
Figure 2-1. The power lines can be from either a power adapter or
in-house power source.
Figure 2-1.
Power Connector
4.
Connect the power connector to the power receptor on the TPC-22
xx
.
The power receptor pin assignment is shown in Figure 2-2.
Figure 2-2.
Power Receptor and Pin Assignment
5.
The system turns on immediately after you apply power.
Touchscreen Calibration
The TPC-22
xx
touchscreen should be correctly calibrated and ready to use
when you power on the system. However, if the calibration is not correct or
you want to choose custom calibration options, refer to Appendix D,
Touchscreen Configuration
.
+
–
GND
GND
–
+