SLSC-12001 Chassis Getting Started Guide and Specifications
|
© National Instruments
|
19
Figure 13.
Fan 3 Wiring Detail
Figure 14.
Tie Anchor Detail
Battery Replacement
The SLSC-12001 contains a lithium cell battery that is required for storing the Real Time Clock
information when the chassis is powered off. There is only a slight drain on the battery when
power is applied to the SLSC-12001 power connector. The rate at which the battery drains when
power is disconnected depends on the ambient storage temperature. The battery is located on the
backplane. To replace the battery, complete the following steps while referring to Figure 15:
1.
Power off the chassis and any power source(s) connected to module(s) and RTI(s).
2.
Remove the chassis power, trigger, and Ethernet cables from the chassis.
3.
Remove the washer and nut from around each BNC connector.
4.
Remove the eight backplane panel fixing screws.
1
Small Grommets
1
Wires
2
Plastic Cable Tie
3
Cable Tie Anchor
1
2
1
3
